RX-8 Application Guide

Step-by-Step 

Effortless Application

RX-8 | Watch Protection Kit

1. Use the microfiber cloth to clean the watch. Make sure there’s no dust, dirt, grease or fingerprints on the surface.
2. Combine two drops of clear liquid detergent or hand soap with 100 millilitres of water in a bowl. Mix well to create the solution.
3. Carefully peel the stencil using tweezers and immerse it into the solution.
4. Place the stencil so it is precisely aligned with your watch’s relevant region.
5. Gently press down to activate the adhesive.
6. If you fail this step, use tweezers to peel off the film on the watch, submerge it into the solution, and place it again.
7. Continue until the watch is coated. Allow a few minutes for it to fully dry before handling.